How to Patch a Large Hole in Drywall

Drywall is a great building material, but it’s relatively easy to damage. Maybe you’re missing a doorstop on one of your rooms and one of your energetic kids has swung a doorknob into the wall, or perhaps you’ve made a nice gash with the corner of a table while moving some furniture around. Regardless of the cause of the damage, repairing a large...

Drywall is a great building material, but it’s relatively easy to damage. Maybe you’re missing a doorstop on one of your rooms and one of your energetic kids has swung a doorknob into the wall, or perhaps you’ve made a nice gash with the corner of a table while moving some furniture around. Regardless of the cause of the damage, repairing a large hole in drywall is an easy task.

Here’s what you will need:

  1. Rectangular piece of drywall slightly larger than the hole
  2. Scrap of plywood wider than the hole
  3. Pencil or marker
  4. Utility knife
  5. Drywall saw
  6. Drill/driver with a Phillips bit or drywall-screw bit
  7. Box of 1-1/2-in. or 1-5/8-in. drywall screws
  8. Mesh drywall tape
  9. Joint compound
  10. Drywall-taping knives

Here’s how to do it:

  1. Measure the width and height of the hole.
  2. Cut a rectangular patch about a half-inch larger than the hole in both dimensions.
  3. Center the patch over the hole and trace it’s shape onto the wall.
  4. Score the lines with a utility knife, then use a wallboard saw to cut from the hole to each corner of the scored rectangle.
  5. Snap the drywall back to the scored lines, and cut the paper backing with the utility knife.
  6. Cut a scrap of plywood the same height as the patch but several inches longer.
  7. Drive a screw in the center of the plywood to use as a handle.
  8. Insert the plywood into the hole, center it, and drive several drywall screws to secure it in place. Then remove the center screw.
  9. Insert the patch and secure with as few screws as necessary to hold it in place.
  10. To finish, apply mesh tape and joint compound to the seams.
  11. After the first coat of joint compound is dry, follow up with another coat of compound over the entire patch, feathering the edges to blend it into the surrounding wall. Repeat the process with additional coats if needed.
  12. Once the final coat is dry, sand it smooth and finish with primer and paint.

More ways to patch drywall:

Small Drywall Patch

This video shows how small holes are handled. You might be familiar with this method. If not, you’ll be glad you checked it out.

This tip shows how tape is used behind the patch.

Nifty Drywall Patch

Check out this video is a combo tip that shows you how to make holes and fix them.

Source: www.finehomebuilding.com